Want to place an ad email luke@realbeer.co.nz
$50+GST / month

RealBeer.co.nz

Hey thought I'd ask this here, proving quite hard to find on google.

I'm after 3 small lengths of stainless tube, enough to make 2 whirlpool tubes and one dip tube.

Tube size, it just needs to fit into 1/2" compression fittings.

Hit me up if you have some spare or have a good source, local or otherwise. Just want the raw tube, not a pre-made fitting.

Cheers!

Views: 2066

Reply to This

Replies to This Discussion

Make sure you get the thin-walled stuff (0.9mm) and if the STC-1000 sensor is a tight fit, just shave the sides off with a very sharp scalpel - don't take too much off though, maybe about 1mm each side max?

I can see me losing a finger with a scalpel, cheers for the help much appreciated

Hi Hamish. If Tata can't help you out, gimme a shout.

will do cheers

Hey Barry.

Where abouts did you get your compression fittings from?

I have a range of compression fittings that I sell. What are you after?

I need to make 2x whirlpool inlet/side drains to fit into 1/2 bsp sockets or elbows if needed.

So fittings and tube needed to do that.

So 1/2" Male thread to 1/2" Compression fittings in Stainless Steel? $20 each for straight and $24 each for 90'.

Keen on 3 of the straight Pls, how much for postage?

I don't but for what it's worth Peter's 5/8" bender worked fine for 1/2" OD pipe.
You are welcome to try it but there is a big difference between 1/2 inch and 6mm. I would be worried if it was copper that it would collapse but the stainless seems very strong.

I have 1/4" / 6.35mm seamless tubing and a bender if required.

RSS

© 2024   Created by nzbrewer.   Powered by

Badges  |  Report an Issue  |  Terms of Service