Want to place an ad email luke@realbeer.co.nz
$50+GST / month
just trying to work out the best way to do a first wort hopping in a BIAB setup, anyone done this and had any success that might point me in the right direction?
Tags:
You could use them as mash hops, not something I have done though. That could be either in the bag or out. But at 70°C I don't think time is a factor in regards to bitterness so they could stay in the whole mash. Other option is to throw them in when you lift the bag and let the bag drain before you put more heat in for the boil.
good ideas, I might have to do a couple of brews side by side with both ideas and see how they go
I have read that its recommended to use low alfa acid hops, no more than 30% of your hop bill ( to minimize the bitterness extracted from the boil) and simply add hops to the bottom of your boiler and run the wort from the mash tun over them prior to the boil. Apparently the reduced heat somehow has the effect of locking in flavour and aroma, reducing vaporization of the delicate oils normally associated with early hop additions and getting a really pleasant hop bitterness in the finished beer. I am going to try FWH in conjunction with very late hopping then addition(s) of infused hop tea during fermentation. I have had great results with adding hop tea to my fermenter just prior to kegging (as an alternative to dry hopping).
Am I correct in saying that the First wort hops act like a 20 mins addition? I think I read that somewhere??
No Idea on how much truth there is to this, but Could be another option?
done a few hours reading today and the general consensus is to add it when you remove the bag then wait a while to allow for sparge time then get the burner cranking, so cheers Scarrfie and Druid that's how I will proceed, will give it a go what's the worst that'll happen I'll just have to brew it again
I've just done a BIAB brew with half the bittering hops as FWH, I added them when I pulled the bag. It took about half an hour to get up to a boil and I figured that was probably fine. Tastes good too.
I do pretty much the same thing when I bother to first wort hop. It seems to be a good technique for certain styles where you want a really clean noble hop character like German Lagers, especially if its going to be your sole addition. I haven't found it to be as useful for hoppier styles, although I did first wort hop a hoppy New Zealand wheat today with a little cascade.
In terms of the IBU contribution, I'm personally don't think you get much from first wort hopping than you would for a 60 or 90 minute addition. I think this is partly because by leaving the hops in solution so long you are probably beginning to breakdown and degrade various hop compounds and allowing them to bind with other compounds in your wort. If you look at the difference in IBU's between a 90 and 60 minute addition it is fairly small.
I've mashed hopped once. Didn't really add anything I could notice as being particularly specific to mash hopping, other than used up some of the crapload of Green Bullet flowers I had! I'm generally a fan of simple 60 minute addition (if at all) followed by big late/whirlpool additions if I am brewing something hop forward.
© 2024 Created by nzbrewer. Powered by