I received feedback from the brews I entered into the SOBA comp (Porter and APA). Both of them contained a phenolic aroma/flavour which let them down!! Good that I know this and now it gives me something to focus on. I’m interested in advice on how to correct this problem. From my research possible causes for the phenols are:
-Chlorophenols in municipal water supplies and residue from chlorine-based sanitizers.
-I don’t use chlorine based sanitizers I use Iodophor so I’m ruling this out.
-Pretty sure our water is low in chlorophenols?
-What about the interior of the hose I use to fill my HLT/mash tun, that’s probably made from PVC, I’ve taken to not using the hose to fill both now.
-Phenols extracted from the mash and during the sparge.
-Not oversparging, I stop the sparge when the runnings reach 1010.
-Not sparging above 170F, usually by the time it hits the mash tun I’m sparging at 74-75C.
-It’s recommended not to use alkaline water for the sparge, my normal tap water is pH 8 just on the alkaline side. Research indicates pH 6.0 being the upper cutoff here.
-Phenols derived from certain yeast strains that produce aromatic alcohols.
-I wasn’t using a Bavarian wheat yeast so could probably rule this one out. Although I was using an older Wyeast 1968 and American Ale II.
-Wild yeast contamination (particularly harboured within plastic based equipment).
-This is a possibility, I do keep all equipment very clean and most of my gear is stainless steel.
-Smokey phenols from smoked malts.
-I can rule this out as no smoked malts were used in the making of these beers.
Any advice would be most welcome
Richee